Description
Looking to add a playful and unique element to your designs? Try out our FashionFlex® Puff HTV in red, a fresh and exciting way to elevate your crafting projects. This puff heat transfer vinyl (HTV) allows for easy application with just one press, delivering a raised and puffed-up effect that's sure to make your designs stand out. Our red puff HTV is super easy to weed, thanks to its pressure-sensitive carrier, and enables effortless repositioning, making it a breeze to work with. Whether you're a professional crafter or a DIY enthusiast, FashionFlex® Puff HTV is perfect for all your creative needs. Get your hands on this must-have crafting vinyl at Molly's Craft Vinyl today!
Application Instructions
Blade – 45°
Cut – Mirror image
Temp – White 290°F
Colors 305°F
Pink and Neons 275°F
Pressure – Medium, even
Time – 10 seconds
Peel – Hot-Remove carrier/transfer sheet immediately
CARE – Wash inside out, cold water, gentle cycle, tumble dry low.
Applies to: Cotton, Uncoated Polyester, Fabric Blends, Polyester/Acrylic, and Similar Fabrics Excluding Nylon
Special Precautions Cannot be layered. Remove carrier immediately after pressing. If the carrier or transfer sheet is left on, it can create inconsistencies in the puffed material.
CUT SETTINGS
PLEASE NOTE: Every blade and machine is a little bit different- always remember to test cut! These cut settings are a starting point to be adjusted to your blade and machine.
CRICUT
- Material: Iron-On
- Pressure: Default
- Blade: Fine-Point Blade
SILHOUETTE
- Material: Heat Transfer, Smooth
- Blade: 3
- Speed: 8
- Force: 10
GRAPHTEC
- Speed: 8
- Force: 18
We use a 45° blade.
Clear plastic side needs to be face down while cutting. Peel up a corner of the carrier to determine this before cutting. Carrier can be shiny or matte depending on batch.
Size is +/- 0.50 inch and +/-3% on length
Colors of products may be different than what the screen on your device shows.
TIP: Always perform a test cut prior to cutting a whole design
Helpful tip-Specialty Materials recommends if your T shirt or material your are putting this HTV on says "dry fit", "Moisture Wicking", or is Gildan Ultra Cotton, use a spray bottle of rubbing alcohol and squirt the material where you are putting the design. Then rub it in a bit with a cloth and dry or even heat press it to dry then press the design. This is due to the material being a coated material, instead of an un coated material.
